Td5 red plug: checking the ECU loom for oil
Engine oil can creep out of the cylinder head along the injector wiring loom and into the plugs. The give-away is oil inside the red connector at the ECU, even though the outside of the wires looks dry.
Signs
- Misfire, rough running or vibration
- Intermittent faults, sometimes with warning lights on the dash
- Oil inside the connectors when you unplug them
Where the ECU is
On the Discovery 2 the ECU sits in the engine bay, next to the battery, under the battery cover. It is usually held by a single self-tapping screw. On a Defender, or if the ECU has been moved, follow the thick loom from the engine.
How to check
- Note your radio code, then remove the battery cover and disconnect the battery earth lead.
- Undo the ECU screw and lift the ECU out. Look at the bottom of the red plug first: a film of oil there is an early warning.
- Unplug both ECU connectors and look inside. Oil pooled in the pins means the loom is carrying oil from the head.
- Check the injector loom connector on the cylinder head too. The oil gets past the two O-rings where the loom passes through the head.
The fix: a new injector loom
- Take off the engine acoustic cover (three 13mm bolts), then the rocker cover. Keep each rocker cover bolt with its bush and rubber washer.
- Unplug the five injectors and the connector underneath where the main loom joins the injector loom, then lift the old loom out.
- Clean the hole in the head carefully with fine abrasive, making sure no pieces of the old O-rings are left behind.
- Fit the new loom, the later revised type, and make sure every injector plug and the lower connector click fully home.
- Fit a new rocker cover seal to the cover rather than the head. Start all the bolts by hand, then tighten them in an opposing pattern to 9 Nm (7 lbf.ft). Check the seal is seated all the way round.
- Clean the ECU plugs with electrical contact cleaner, refit the ECU, reconnect the battery and test. Check the red plug again over the next few weeks until no more oil appears.
Allow about two hours. Don't leave it: oil reaching the ECU costs far more than a loom.
A detailed photo write-up of the Discovery 2 job is at discovery2.co.uk.
Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.
Engine and service parts