Skip to content
Shop parts Basket0

Discovery 2 propshaft universal joints

The front propshaft's double joint at the transfer box was fitted at the factory with non-greasable joints. When it fails it can damage the transfer box, so rebuilding it with greasable joints is good preventive work.

The job

  1. Mark each propshaft against its flanges with a file before removal, so it goes back in exactly the same position and doesn't vibrate.
  2. Undo the four nuts and bolts at each end and remove the shaft.
  3. Remove the circlips, press out the old joints and press in new greasable joints, fitting new circlips.
  4. Refit to your marks, tighten to the figures below and grease every nipple, including the sliding splines.
Torque figures
FixingTorque
Propshaft to transfer box47 Nm (35 lbf.ft)
Propshaft to differential47 Nm (35 lbf.ft)
Propshaft to rear flexible coupling76 Nm (56 lbf.ft)

Worth knowing

  • The rear shaft uses a rubber flexible coupling at the differential, which is replaced, not repaired.
  • Grease the joints at every service once they are greasable.

Step-by-step photos of a Discovery 2 doing this job: discovery2.co.uk.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Axles and diffs
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.