Skip to content
Shop parts Basket0

Discovery 2 front discs and pads

Replace the discs once they reach the service limit or have a heavy lip, and always replace pads as an axle set. Fade on long descents is a sign both are due.

The job

  1. Loosen the wheel nuts, raise one side on a trolley jack and put it on an axle stand, then remove the wheel.
  2. Remove the caliper guide pin bolts and move the caliper aside on a hook. Do not let it hang on the hose.
  3. Remove the countersunk disc retaining screw (have new ones ready, as they often chew up) and take off the disc.
  4. Clean the hub face, fit the new disc and screw, push the piston back and fit the new pads.
  5. Refit the caliper, the wheel and tighten the nuts to 140 Nm. Pump the pedal before moving and bed the pads in gently.
Torque figures
FixingTorque
Caliper guide pin bolts30 Nm (22 lbf.ft)
Front caliper mounting bolts175 Nm (129 lbf.ft)
Disc retaining screw13 Nm (10 lbf.ft)
Wheel nuts140 Nm (103 lbf.ft)

Worth knowing

  • Front disc thickness: 25mm new, replace at 22mm. Pads: replace at 2mm of friction material.
  • Drilled and slotted discs help on the road but can clog with mud if you go off-road a lot.

Step-by-step photos of a Discovery 2 doing this job: discovery2.co.uk.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Brakes
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.