Skip to content
Shop parts Basket0

LT230 output shaft oil seals

Oil dripping from the front or rear output flange, or oil on the handbrake drum, means an output seal is leaking. Left alone it drops the oil level and can contaminate the handbrake shoes.

The job

  1. Remove the propshaft from the flange you are working on, marking it first so it goes back in the same position.
  2. Rear seal only: slacken the handbrake shoe adjuster and remove the handbrake drum.
  3. Hold the flange with a flange holding tool, remove the flange nut and the steel and felt washers (all three are replaced), then pull off the flange.
  4. Lever out the old seal without scoring the housing. Clean the seat, oil the new seal with gear oil and drive it in squarely with a seal installer.
  5. Refit the flange with new felt and steel washers and a new nut, tightened to 148 Nm while held with the tool.
  6. Rear seal: refit the drum, tighten the shoe adjuster to 25 Nm, then back it off one and a half turns, and check the drum turns freely. Refit the propshaft and top up the oil.
Torque figures
FixingTorque
Drive flange nut, new (in vehicle)148 Nm (109 lbf.ft)
Handbrake shoe adjuster, then back off 1.5 turns25 Nm (18 lbf.ft)
Propshaft to transfer box47 Nm (D2) / 48 Nm (Defender)

Worth knowing

  • The LT230T overhaul manual gives 162 Nm for the output flange nuts when the box is rebuilt on the bench.
  • Worn flange splines or a scored seal track on the flange will chew a new seal quickly. Replace the flange if it is marked.
  • Rebuilding or upgrading the box? See the Winchester Gears LT230 builds.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Gearbox and transfer box
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.