Skip to content
Shop parts Basket0

Td5 oil pump sprocket bolt check

The bolt holding the oil pump drive sprocket can work loose because early engines left the factory without threadlock on it. If it falls out the oil pump stops and the engine is wrecked. Checking it is cheap insurance, especially on early engines, and worth doing with a sump gasket or oil change.

The job

  1. Raise the vehicle high on axle stands under the chassis so the front axle can drop, and drain the engine oil.
  2. Remove the under-tray, the front crossmember, the gearbox oil cooler pipe clips at the sump, and the drain pipe from the oil centrifuge to the sump.
  3. Remove the sump bolts, including the four through the bell housing, and lower the sump.
  4. Remove the sprocket bolt, clean both threads, apply threadlock and refit it to 25 Nm.
  5. Refit the sump with a new gasket, refill with oil and check for leaks.
Torque figures
FixingTorque
Oil pump drive sprocket bolt (with threadlock)25 Nm (18 lbf.ft)
Oil sump to cylinder block bolts25 Nm (18 lbf.ft)
Oil sump to bell housing bolts13 Nm (10 lbf.ft)
Front crossmember bolts26 Nm (20 lbf.ft)

Worth knowing

  • Later engines were built with threadlock, but loose bolts have still been found on 2003 and 2004 vehicles.

Step-by-step photos of a Discovery 2 doing this job: discovery2.co.uk.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Engine and service parts
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.