Skip to content
Shop parts Basket0

Td5 cooling system layout and bleeding

The Td5 runs hot under load, so trapped air after a coolant change shows up quickly as overheating or no heat inside.

Td5 cooling system: engine, thermostat, radiator, expansion tank and heater, with the places air gets trapped Radiator Enginewater pump Thermostat Heatermatrix Expansion tank top hose, to radiator cooled, back to the engine A B
Simplified layout. A: the bleed screw in the radiator top hose, used when refilling. B: the heater feed hose, where air most often gets trapped.

Refilling without an airlock (Land Rover method)

  1. With the engine cold, take the bleed screw out of the radiator top hose.
  2. Unclip the bleed hose from the battery box. Unclip the expansion tank from its bracket, take the cap off and hold the tank about 10cm (4in) higher.
  3. Fill slowly through the expansion tank until coolant runs steadily from the bleed hole.
  4. Refit the bleed screw and, with the tank still raised, keep filling to the cold level mark.
  5. Refit the cap and tank, run the engine to normal temperature with the heater on full and check for leaks.
  6. Let it cool completely, then top up to the cold mark. Check again after the next couple of drives.

Some owners still find air in the heater feed after this. Parking nose up for the fill helps.

Losing coolant with no sign of where it goes, or air that keeps coming back, needs looking at properly. Cooling parts or ask Dean.

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Cooling parts
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.