Skip to content
Shop parts Basket0

Discovery 2 front shock absorber lower bushes

Worn lower bushes let the front dampers move about, giving knocks and vague handling. If the dampers are tired as well, new dampers usually come with new bushes.

The job

  1. Raise the front on axle stands, remove the wheel and support the axle: the damper is what stops it dropping.
  2. Soak and remove the two lower bolts and the four nuts holding the turret on top. Note which way the top damper bolt faces.
  3. Push the damper up into the turret and lift the whole assembly out from the engine bay. On a Td5, unclipping the coolant expansion tank gives more room.
  4. Press the old bush out and the new one in with a press or a large vice, keeping it the same way round.
  5. Refit the assembly and tighten to the figures below with the weight on the wheels.
Torque figures
FixingTorque
Damper to front axle55 Nm (40 lbf.ft)
Turret to chassis23 Nm (17 lbf.ft)
Wheel nuts140 Nm (103 lbf.ft)

Worth knowing

  • On vehicles with ACE, a pipe bracket sits on the driver's side turret studs and has to be eased aside.

Step-by-step photos of a Discovery 2 doing this job: discovery2.co.uk.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Engine and service parts
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.