Skip to content
Shop parts Basket0

Defender front brake pads

The Defender front calipers hold their pads with retaining pins and split pins, so pad changes are quicker than on a Discovery 2. Replace pads as an axle set once they are down to 2mm on vehicles from 2002 (3mm on earlier ones).

The job

  1. Raise the front on axle stands and remove the wheels. Clean the outside of the calipers.
  2. Remove the split pins, then the pad retaining pins and anti-rattle springs, and lift the pads out.
  3. Clean the exposed parts of the pistons with new brake fluid, then press each piston back with a piston clamp. Watch the reservoir so it doesn't overflow.
  4. Fit the new pads with the leading edge chamfer the right way round, then the retaining pins and springs, secured with new split pins.
  5. Press the brake pedal several times to bring the pads up, refit the wheels and tighten the nuts to 130 Nm. Top up the fluid if needed.
Torque figures
FixingTorque
Wheel nuts130 Nm (96 lbf.ft)

Worth knowing

  • Always use new split pins.
  • Wheel nut torque depends on the wheel: 130 Nm for alloy, 100 Nm for steel and 170 Nm for heavy duty wheels.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Brakes
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.