Skip to content
Shop parts Basket0

Defender front shock absorbers and bushes

Knocks from the front, a wallowy ride or perished rubber bushes at either end mean the dampers need attention. Each end uses a rubber bush between two cup washers, so bushes can be renewed with the damper or on their own.

The job

  1. Loosen the wheel nuts, put the chassis on axle stands, remove the wheel and support the axle with a jack.
  2. Remove the lower fixing and take off the cup washer, rubber bush and seating washer, noting their order.
  3. Remove the four fixings holding the damper bracket on top and lift the damper and bracket out together.
  4. On the bench, remove the damper from the bracket and take off the top seating washer, bush and cup washer.
  5. Build the new damper up with new bushes in the same order, refit it with its bracket and secure the four fixings, then the lower fixing.
  6. Tighten the damper mountings to 38 Nm, refit the wheel and lower the vehicle.
Torque figures
FixingTorque
Shock absorber upper and lower mountings38 Nm (28 lbf.ft)
Wheel nuts, alloy / steel / heavy duty130 / 100 / 170 Nm

Worth knowing

  • After tightening, at least two threads should show beyond each nut, top and bottom.
  • Figures from the Defender 2007 model year manual; the front damper layout is the same on the Td5.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Engine and service parts
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.