Skip to content
Shop parts Basket0

Td5 injector seals and washers

Leaking injector seals let diesel into the sump. Signs are a rising oil level, oil that smells of diesel on the dipstick, poor starting and rough running. Diesel thins the oil, so don't keep driving it.

The job

  1. Remove the acoustic cover, the camshaft cover and the injector wiring loom (a good time to fit the revised loom).
  2. Remove the viscous fan, then turn the engine to number 1 cylinder at top dead centre (number 1 is at the pulley end) and lock the camshaft with the timing pin.
  3. Slacken the rocker adjusting screws, then remove the rocker shaft, undoing its six bolts evenly from the middle outwards.
  4. Drain the fuel from the head at the fuel cooler and regulator connections.
  5. Write down each injector's code and its cylinder, then remove the clamps and injectors, keeping every part in order.
  6. Fit new O-rings and copper washers, refit each injector in its own cylinder and tighten the clamp bolts to 32 Nm.
  7. Refit the rocker shaft to 32 Nm, set the injector rockers to the manual's procedure, then refit everything else.
Torque figures
FixingTorque
Injector (EUI) clamp bolts32 Nm (24 lbf.ft)
Rocker shaft bolts32 Nm (24 lbf.ft)
Rocker adjusting screw locknuts16 Nm (12 lbf.ft)
Camshaft cover bolts10 Nm (7 lbf.ft)
Viscous fan nut45 Nm (33 lbf.ft)

Worth knowing

  • Each injector must go back in the same cylinder: the ECU is coded to it. Mixing them up means reprogramming with a diagnostic tool.
  • 15P and 16P engines use green-top injectors and earlier engines black-top. They are not interchangeable.
  • The viscous fan has a normal right-hand thread. Td5 fan spanners make it far easier.
  • Land Rover says to renew the rocker shaft bolts, adjusting screws and locknuts.

Step-by-step photos of a Discovery 2 doing this job: discovery2.co.uk.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Engine and service parts
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.