Td5 in-tank fuel pump replacement
The Td5 has an electric pump and fuel gauge sender inside the tank. A noisy pump, a gauge that drops to empty, or an engine that will only idle all point to it. On a Discovery 2 it is reached through a panel under the boot carpet. On a Defender the tank has to come off first.
The job
- Run the tank as low as possible first; the job is far easier with the fuel warning light on.
- Discovery 2: remove the rear carpet trim strip and loosen the lower side trims so the carpet can be lifted forward, then remove the access panel.
- Defender: drain the tank, disconnect the battery, unplug the pump and its four fuel hoses (note where each goes), support the tank and lower it out with its support plate.
- Disconnect the battery, unplug the pump and release the fuel pipes, catching any spill.
- Unscrew the locking ring (Land Rover tool LRT-19-009), lift the pump and sender out carefully without bending the float arm, and fit the new unit with a new sealing ring.
- Reconnect, refit the panel and trims or the tank, then check for leaks with the ignition on before starting.
| Fixing | Torque |
|---|---|
| Defender fuel tank nuts and bolts | 25 Nm (18 lbf.ft) |
Worth knowing
- A noisy pump can also be a blocked fuel filter, a sticking valve in the filter head or leaking injector seals, so check those first.
- Diesel vapour is flammable: work in the open, with no sparks or flames nearby.
Step-by-step photos of a Discovery 2 doing this job: discovery2.co.uk.
Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.
Engine and service parts