Skip to content
Shop parts Basket0

Defender front discs and hub

On a Defender the front disc comes off with the hub, so a disc change is also the time to check or renew the hub bearings. Discs on 110 and 130 models are 24mm new, with a wear limit of 1mm per side.

The job

  1. Raise the front on axle stands and remove the wheel. Clamp the brake hose, disconnect the pipe from the jump hose (two spanners) and plug it.
  2. Remove the two caliper bolts and the caliper.
  3. Remove the dust cap, the circlip and shims from the drive shaft, then the five driving member bolts (throw them away) and the driving member and gasket.
  4. Knock back the staking and remove the hub nut (new one needed) and washer, then pull off the hub and disc complete with bearings.
  5. Fit the new disc to the hub. Refit the hub, fit the washer and a new hub nut, tighten to 30 Nm, rotate the hub to settle the bearings, then tighten to 210 Nm.
  6. Check drive shaft end float with a dial gauge and change the spacer if there is any. Stake the nut.
  7. Fit a new driving member gasket and new bolts (65 Nm), the shims and circlip, then the caliper (82 Nm). Reconnect the pipe, bleed the brakes and refit the wheel (130 Nm).
Torque figures
FixingTorque
Hub nut, first30 Nm (22 lbf.ft)
Hub nut, final210 Nm (150 lbf.ft)
Driving member bolts, new65 Nm (48 lbf.ft)
Front caliper bolts82 Nm (60 lbf.ft)
Wheel nuts130 Nm (96 lbf.ft)

Worth knowing

  • You need a dial gauge to check end float, and the right spacer if there is any.
  • Bleed the brakes afterwards and press the pedal to bring the pads up before driving.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Brakes
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.