Skip to content
Shop parts Basket0

Defender propshafts

Worn universal joints show up as a clunk taking up drive or a vibration at speed. The Defender shafts use greasable joints and a sliding spline, so regular greasing keeps them going.

The job

  1. Centre-punch the shaft against each flange before removal so it goes back exactly as it came off.
  2. Front shaft: release it from the front differential flange to get the underbelly panel off, then remove the four nuts at the transfer box flange.
  3. Rear shaft: remove the four nuts at the park brake flange and the four nuts and bolts at the rear axle flange. Turn the shaft as needed to reach them.
  4. Replace worn joints: remove the circlips and grease nipple, tap the yokes to free the cups, fit the new spider and cups, and refit new circlips.
  5. Grease the joints and splines, refit to your marks and tighten the flange nuts to 48 Nm.
Torque figures
FixingTorque
Propshaft flange nuts48 Nm (35 lbf.ft)

Worth knowing

  • Mark the spider position against the yoke before taking a joint apart, to keep the shaft in balance.

Rather have it done? Book it in with Dean

Rather have Dean do it? Fitting is at our Pelsall workshop, by appointment only.

Axles and diffs
AIRTEC MotorsportAlliSport15 years working on Td5sDemand EngineeringThe price you see is the price you payWinchester GearsFitting at our Pelsall workshop, by appointmentLOF ClutchesNever more than buying directTD5Inside

Check your vehicle by VIN

We read your model, engine and year from the VIN and show the parts that fit.

On your V5C logbook (box E), on the plate by the passenger seat, or on the chassis by the front right wheel.